JCU-2 Joystick Control Unit & POE Injector Kit
JCU-2 Joystick Control Unit
The joystick is the primary control for the M400 & M400XR and the new M300 series (M300C, M332, M364, M364C, and M364C LR. It is used to wake the system or put it in standby, operate the pan and tilt movement, zoom the camera, control cameras modes and features, and configure system settings by means of OSD menus.
- Joystick Control Unit (JCU2)
- Mounting hardware
Power Over Ethernet Injector – 12V
FLIR’s 12V Power Over Ethernet Injector is a key component in connecting your FLIR maritime thermal imaging camera to an Ethernet-equipped Joystick Control Unit.
- JCU-2 keypad
- Keypad mat
- Mounting gasket
- 4 x mounting screws, rubber washers, mounting clamps
- Cable gland nut
- RJ45-to-RJ45 Ethernet cable, 7.6 m (25 ft)
- Documentation pack
- POE injector